Problem 1: The sections of your telescopic poles no longer lock properly
Older models from the Leki Makalu range are particularly well known for this issue. At some point, the telescopic poles stop holding the desired length, and the individual sections slide into one another under load. Not only is this annoying, but depending on the terrain, it can also be dangerous. Let’s take a look at what you can do if the locking mechanism no longer secures the pole sections reliably.
Many Leki poles use one of two common adjustment systems: Super Lock or Speed Lock Plus / Speed Lock 2 Plus.

The Super Lock System from Leki
The Super Lock System is an internal locking mechanism located inside the pole sections. The sections are locked by twisting them against one another. This system is typically found on older or more basic models.
When new, it generally works very well. However, repeated use or improper handling can cause the expansion plug or locking sleeve inside the pole to lose its grip. As a result, the sections collapse under pressure. To fix the issue:
- Open the lock and pull the affected sections apart completely until they are separated.
- The lower section contains the locking mechanism. Check whether the black locking sleeve shows signs of damage or wear.
- If the sleeve is damaged, it must be replaced. Replacement parts are available from Leki. If it is not damaged, it usually only needs readjustment.
- If necessary, replace the sleeve and screw it upwards (turn clockwise) until it is just slim enough to fit back into the upper pole section.
- Reassemble the pole and lock it as usual. Your Leki poles should now maintain their length reliably under load.
The Speed Lock Plus System from Leki

The Speed Lock Plus and Speed Lock 2 Plus systems use an external clamp mechanism. The principle is similar to the seat-post clamp on a bicycle. By opening or closing a lever, the pole can be adjusted and locked at the desired length. These systems are generally very reliable, but they too can develop issues over time. If that happens:
- Inspect the mechanism for visible damage. If the lever or the nut on the opposite side is broken, the defective component must be replaced. Leki offers suitable spare parts.
- If there is no obvious damage, the clamp usually just needs tightening. Open the lever and tighten the small retaining nut slightly. This can often be done without tools and usually requires only a small adjustment.
- Once adjusted, the poles should lock securely again.
Problem 2: The pole basket is damaged
Skiers in particular might be familiar with this problem. After repeated contact with ski edges, the basket eventually becomes damaged. Or perhaps you’ve noticed that your ski poles sink too deeply into soft snow. In short, the snow basket needs replacing. Here’s how:
- Remove the old basket. In theory, baskets can be unscrewed with little force. However, on older models this is often no longer possible. In that case, some brute force may be required. For example, lightly secure the basket in a vice and pull the pole free with a sharp tug. Be careful not to damage the basket mount on the pole tip.
- Check the pole tip for damage. If it is damaged, it should also be replaced. See Problem No. 3 below.
- If the tip is in good condition, screw the new basket onto the mount. It should fit securely in place.
Please note: this procedure only applies to models with threaded baskets. Some poles, particularly cross-country ski poles, have baskets that are glued together with the tip. In that case, follow the instructions for replacing the pole tip.
Problem 3: The pole tip is damaged

Trekking, trail running and hiking poles are often subjected to heavy wear. Once the pole tips become too worn, they lose grip on many surfaces and need to be replaced.
On many Leki poles, the tips can be replaced. They are usually glued in place and can be removed quite easily using the right technique, such as the Flex Tip Short and Flex Tip Long versions. In the cross-country skiing sector, there are also poles featuring the Fin Vario System, which allows particularly quick and simple tip changes.
Replacing Glued-On Tips
Leki pole tips are typically fixed using a hot-melt adhesive. As this adhesive softens when heated, replacing the tip is relatively straightforward:
- If your pole has a threaded basket and you want to reuse it, remove the basket first as described above. If the basket is already damaged, it can remain attached.
- Place the lower end of the pole in hot water for around 10 minutes to soften the adhesive.
- Twist and pull the tip off.
- Remove any adhesive residue from the shaft and apply fresh adhesive. This special hot-melt adhesive is also available from Leki.
- Fit the new tip onto the shaft and adhesive, then allow it to cool and set. If the tip is asymmetrical, make sure it is aligned correctly with the handle before the adhesive hardens.
Fin Vario System
The Fin Vario System is a quick-change system developed specifically for cross-country skiing and roller-ski poles. Different baskets and tip combinations can be swapped quickly and without tools, allowing you to adapt to varying conditions. In this system, the tip is screwed onto the shaft and can simply be removed or attached by twisting it.
Problem 4: The pole grip is worn out

Sweat, dust, dirt and general wear all take their toll on pole grips over time. Fortunately, a damaged grip doesn’t mean the end of your favourite Leki pole. With the right approach, grips can also be replaced.
Like the tips, Leki pole grips are bonded using a heat-sensitive adhesive, so the process is very similar:
- Place the grip end of the pole in hot water for around two minutes until the adhesive softens.
- Pull the grip off while gently twisting it.
- Clean away any old adhesive and apply fresh hot-melt glue.
- Push the new grip onto the shaft. This may require a little force. You can place the grip on the floor or a table and press the shaft down into it. Once the grip is seated fully, it can still be rotated slightly, so ensure it is aligned correctly before the adhesive hardens.
As you can see, even significant damage doesn’t necessarily mean your poles need replacing. Do you have any additional tips for carrying out a Leki pole repair, or have you successfully repaired your own Leki poles? We’d love to hear about it in the comments.